Carpentry advice for Bromsgrove

How to measure an alcove for shelves and cupboards

A carpenter will measure up properly on the day. A few rough figures before that help them quote more closely, and tell you if your idea will fit. All you need is a tape measure and a pencil.

Measure the width in three places

Take the width at the top, the middle and near the floor. Old walls lean and bulge, so the three numbers are often different by a centimetre or more. Note all three. The carpenter will cut to the narrowest point and scribe the edges.

Measure the height

Measure from the floor to the ceiling at the back of the alcove. If the ceiling has a coving, note how far it drops. If the alcove has a picture rail, a high skirting or a dado, mention that too.

Measure the depth

Measure from the back wall to the front edge of the chimney breast. This tells the carpenter how deep the shelves can be. Many alcoves are shallow at the top and deeper lower down. Cupboards below the shelves usually need more depth than the shelves above.

Look at what is in the way

Note down any sockets, switches, aerials, radiators and pipes. Write where each sits, measured from the floor and from the side wall. If there is a window beside the alcove, check how close it is to the edge of the shelves.

Decide what the shelves are for

Think about what will go on them. Books need strong shelves and closer supports. A television needs a flat, deep shelf and a way to run the cable. Ornaments need spacing that suits their height. If you know the tallest thing you want to store, tell the carpenter.

Take a photo

A photo of the alcove from the middle of the room helps you remember what you saw, and is handy during the call. You can describe it in the form. The carpenter may ask you to send a photo later, if they need one.

Check the floor and the ceiling

Put a spirit level on the floor of the alcove. Floors often slope towards the chimney breast, and a unit that sits on a sloping floor needs packing under it. A ceiling that dips tells the carpenter that the top shelf will have to be cut to follow it, or kept clear of the edge.

Look at the skirting board, too. It usually runs along the back and sides of an alcove. The carpenter will need to cut it away or fit the unit around it, and that choice affects the finished look.

Pick the finish before the visit

Painted, stained or bare timber, each leaves a different amount of work. Painted units need filling, sanding and several coats, which adds time. Bare timber is quicker, if you plan to finish it yourself. Tell the carpenter which you prefer, and say who will do the painting, so the quote matches.

Common questions

Do both alcoves need to match?

They do not have to, but most people like them to. Chimney breasts are often not centred, so the two alcoves can be different widths. A carpenter can make the units look the same by keeping the shelf spacing and trim equal.

Should I clear the alcove before the visit?

Yes, as far as you can. Move furniture and ornaments so the carpenter can reach the walls. Leave anything that is fixed, such as sockets and pipes, where it is.

Ask for a free alcove shelving quote

Rough measurements are enough to start. The carpenter will take the exact ones when they visit.

Use the short form, add your sizes and name a time to ring. A quote based on your sizes is free.

Ask for a free carpenter's quote

Four short boxes and a call back time. No email needed.

By sending this form you agree to your details being shared with a local carpenter so they can contact you. See our privacy notice.

Get a free quote